Definition of Cutter head. Meaning of Cutter head. Synonyms of Cutter head

Here you will find one or more explanations in English for the word Cutter head. Also in the bottom left of the page several parts of wikipedia pages related to the word Cutter head and, of course, Cutter head synonyms and on the right images related to the word Cutter head.

Definition of Cutter head

Cutter head
Cutter Cut"ter (k?t"t?r), n. 1. One who cuts; as, a stone cutter; a die cutter; esp., one who cuts out garments. 2. That which cuts; a machine or part of a machine, or a tool or instrument used for cutting, as that part of a mower which severs the stalk, or as a paper cutter. 3. A fore tooth; an incisor. --Ray. 4. (Naut.) (a) A boat used by ships of war. (b) A fast sailing vessel with one mast, rigged in most essentials like a sloop. A cutter is narrower end deeper than a sloop of the same length, and depends for stability on a deep keel, often heavily weighted with lead. (c) A small armed vessel, usually a steamer, in the revenue marine service; -- also called revenue cutter. 5. A small, light one-horse sleigh. 6. An officer in the exchequer who notes by cutting on the tallies the sums paid. 7. A ruffian; a bravo; a destroyer. [Obs.] 8. A kind of soft yellow brick, used for facework; -- so called from the facility with which it can be cut. Cutter bar. (Mach.) (a) A bar which carries a cutter or cutting tool, as in a boring machine. (b) The bar to which the triangular knives of a harvester are attached. Cutter head (Mach.), a rotating head, which itself forms a cutter, or a rotating stock to which cutters may be attached, as in a planing or matching machine. --Knight.

Meaning of Cutter head from wikipedia

- a cutter is a 3⁄4 facelock bulldog maneuver. This move sees an attacking wrestler first apply a 3⁄4 facelock (reaching back and grabbing the head of...
- from the tip of the jaw to the end of the handle. Angle cut has the cutter head angled for easier insertion. Typical angling is 25 to 35 degrees. Center...
- lathes utilize an audio signal, sent through a cutting amplifier to the cutter head, which controls the cutting stylus. The cutting stylus engraves a modulated...
- cylindrical cutter head such that their cutting edges protrude from the cutter head so that they will come into contact with the board being cut as the cutter head...
- segments. The cutter head uses a combination of tungsten carbide cutting bits, carbide disc cutters, drag picks and/or hard rock disc cutters. EPB has allowed...
- surfaces. It is different from a surface planer, or jointer, where the cutter head is set into the bed surface. A surface planer has slight advantages for...
- rotary cutters to remove material by advancing a cutter into a workpiece. This may be done by varying directions on one or several axes, cutter head speed...
- reported. Further inspection after the cutting head was removed and dis****embled showed damage to the cutter head drive gears, so a new estimate of the repair...
- oriented spindle drives one or more stacked cutter heads to mill profiles on wood stock. Wood shaper cutter heads typically have three blades, and turn at...
- a jointer, is an out-feed table which is set too low relative to the cutter head. The predominant cause of snipe in a thickness planer is change in the...